Counting matching models…
I've printed it in ABS as car can get quite hot in the sun, on the picture there is a fuzzy skin option used but printing next time I'd skip that, the effect is not even close to the original facture
A remix to get longer tools of Kärcher VC7 to face down In holes I've used M3x30 bolts, 3 of them might be an overkill but hey, it holds ;)
I've lost one slider for the boaxel basket It feels that PETG works better, but PLA wasn't far off, print in 100% fill and full supports
I've needed some weights to hold fabric straight, there are 9 holes inside (H:19 x Φ:13 mm) made to match lead weights I've had lying around, you can enlarge them with a negative volume in the slicer if needed the design on top is just to…
Just a simple battery door, fits really snug
I was tired of my car radio lag between powering up and pairing via BT (only functionality I ever use) so I've bought BT receiver (XH-A105) and made a fitting pocket, there is also small space left perfect for sunglasses additionally…
Simple finger protector to not get cut by the overlock knife, snaps to the side of the bottom cover
45 deg holder for a led strip, all credits to @vr6syncro just needed 25cm one so I've elongated it and added one more anchor point
Storage Solution for 2 SUNLU 5kg Spools (55x150mm inner hole) Required Hardware: 1x IKEA KUGGIS box (32x32x32 cm) 4x 608 bearings 1x M6 threaded rod (33 cm) 5x M6 nuts 2x PTFE tubes 1x 6mm wood drill bit Assembly Instructions: Drill the…
These are all currently available results.
