Counting matching models…
Fully customizable bin cutter. Take whatever design you want and then lop off an end or two (or three). Simple bin cuts stls are included. With this you can create—or just use the included—open ended bins, corners of bins, or just the…
Several sizes provided as STLs. SCAD provided to allow you to create your own size. The image shows a gridz value of 3. The vials were empty and stayed in when I jostled it about. So I expect full vails to have a lower center of gravity…
3u trays work well for thinner writing instruments, such as pencils, thinner pens (nothing thicker than a Pilot Metropolitan/Cocoon - 15.8mm) 4u trays work for most pens, although it would likely be too small for a Namiki Emperor or other…
Migrate any Rolodex cards into your Gridfinity organization system. Four different sizes included: 3 units wide and 1-4 units deep. Also, the OpenSCAD is included to allow you to customize it to your use case.
My funnel extends past 1x1 when it sits in the stand, but it is above surrounding bins, so it works for me. Change the dimensions is the SCAD file to 1.5x1.5 or 2x2 to fit your use case. Scad file is included and uses Gridfinity Rebuilt…
Pen tray inserts for your GEN2 drawers. Comes in all sizes. Made to fit inside Jerrari Design's GEN 2 Modular System Drawers. Mini, Standard, and Large sizes work for 1W and 2W widths. Small and Medium sizes only work for 2W width with…
1.5x4 and 1.5x3.5 Gridfinity storage bin for a Japanese style jigger. The 8 height variant allows for possible stacking (if your drawer is that deep). I you want it widen it to take up 2 wide, then you can simply edit the SCAD file. Same…
Default shelf depth is same a width. This is completely configurable in the SCAD file. The 6f (class RackRPi) file provided is only 4f deep.
1x4 Gridfinity storage bin for a cocktail strainer. The narrow offset version should be right for most julip strainers and the narrow (centerline) one should work for most Hawthorne strainers. Other sizes provided to allow you to pick the…
The filament sample card I use is linked below. This bin is designed to hold them upright. However it will work with most filament cards that are 2mm thick. Filament Sample Card ( MakerWorld ) Gridfinity Rebuilt OpenSCAB Github page
1x5 and 1x4.5 Gridfinity storage bin for a cocktail fine mesh strainer strainer. The channel is offset to fit the strainer. Top and bottom cuts of each variant are provided for smaller printers. Gridfinity Rebuilt OpenSCAB Github page
This is meant to hold a step jigger upside down to let it dry. It comes in single jigger (1.5x1.5) and two jigger (1.5x3) variants. I measured it to hold my jigger just off the base to let any moisture dry after it has been washed.
1x2 Gridfinity bin for the SmartThings Multipurpose Sensor Gen 2. It holds two sensors and five CR2450 batteries, which are the kind used by the sensor.
These are all currently available results.
