Counting matching models…
This is my design of a small (35 mm outer diamater) but usefull star knob for M6 screws or nuts. Tight fit, needs a counter part to screw in. I also used a 6 mm drill bit to fine tune the hole for the thread. Print Settings Printer:…
Clip on dust extraction for the Makita 3709 edge router/trimmer base to use with a 35 mm shop vac. Due to I was not able to find a design with either the right diameter for my 35 mm shop vac or the possibility to see what the router bit…
I used this Knob: https://www.printables.com/model/255727-star-knob-m6
Inspired by LooseArrow I designed a radius gauge for radius 5, 10, 15 and 20 mm to use e.g. in woodworking projects. In my design the radii in the respective corner and the outer corner have the same radius to use it more versatile and I…
Router Circle Jig (Fräszirkel) for Makita 3709 very small circles up to appx 300mm diameter countersunk M4 srew needed
A spare for the stressless swing table if broken
Designed for a D 10mm H 3mm magnet and TPU filament
Parallel guide for Festool guide rail with 6 mm rod and M6 screw for repetitive thin cuts on the waste side
Modified part to install a button into the hole of the Bambulab P1S, e.g. to switch on/off an additional USB LED light strip. I used these switches: https://www.amazon.de/dp/B00XA3RDQI?psc=1&ref=ppx_yo2ov_dt_b_product_details
Print with 0,2 mm layer height and the front surface on the print bed.
Inspired by LooseArrow I designed a radius gauge for radius 5, 10, 15 and 20 mm to use e.g. in woodworking projects. In my design the radii in the respective corner and the outer corner have the same radius to use it more versatile and I…
I used these inserts for ¼": https://www.amazon.de/dp/B09NM8YV8H?ref=ppx_yo2ov_dt_b_product_details&th=1 and M4 ones for the fixation screw. The print was oriented on its front/back to increase strength.
adds the width of the blade to the guide rail to get precise waste side cuts
Remix of a DIY router plane to fit the Veritas 1/2" blade, an ¼" insert and a ¼" camera screw.
I designed a corner radius routing jig to route inside and outside corners with a radius of 10, 15, 20 or 25 mm with a flush trimming router bit. The edge guide of this jig can be mounted outwards or inwards to allow both types of…
My design of a Bicycle Bag Hanger. I wanted to fix my Ortlieb bike bags to a shelf and needed a fitting solution. The tube a 8x1 mm aluminum extrusion. Print Settings Printer: Renkforce RF100 V2 Rafts: No Supports: Yes Resolution: 0.2mm…
The Thing are two adapter pieces to use the Bosch 1600A0014U raplacement sanding sleeve together with a skateboard ball bearing and a M8 treaded rod as a sanding drum in your drill press. Link to the sanding sleeve:…
Print with increased infill for stability
The cable is included with the J33 BT adapter (https://amzn.eu/d/bvBbztL). The adapter snaps right into the model, the buttons and ports are still usable and even the mic works great as a headset.
recommended to print with brim
These are all currently available results.
