Counting matching models…
16cm x 8cm small shelf panel for IKEA Skadis board. The fixture is snug fit providing a very sturdy platform for displaying small objects. A small bump is added in the middle for extra security. The panels can be placed side by side.…
8cm x 8cm small shelf panel for IKEA Skadis board. The fixture is snug fit providing a very sturdy platform for displaying small objects. A small bump is added in the middle for extra security. The panels can be placed side by side.…
A XBOX controller holder for IKEA Skadis board. Tested with XBOX ONE and XBOX 360 (wired) controller. The wide gap in the centre for the thumb to lift controller up. Snug fit to the board. Update - 01 Apr 2024: re-exported the project…
A small pen holder for IKEA Skadis board that holds 2 pens with up to 1.5cm diameter. Takes up 3 holes across 2 vertical columns and another holder can be hooked up immediately next on either side. Lines up well with ‘ Pen Holder ONE ’…
A small pen holder for IKEA Skadis board that holds a single pen with up to 1.5cm diameter. Takes up only 2 holes vertically and another holder can be hooked up immediately next on either side. Lines up well with ‘ Pen Holder TWO ’ which…
A front-load rack for beer cans (440ml) that holds 5 cans. Direct access to any cans in the rack. Can store shorter cans (330ml) as well. The front end is slightly raised to avoid cans sliding out. Connect another FIVE or EIGHT rack on…
Small and simple hook for IKEA Skadis board. The hook is snag fit to the board, ideal for hanging smaller objects - key rings, netsuke, capsule toys etc. Update - 01 Apr 2024 Re-exported the project file using ‘Generic 3MF’ from Bambu…
Small card holder for IKEA Skadis board. Snug fit for one hole. Clips and holds very thin paper (receipt), post-it, postcard, business card, photo, playing card… - Tested up to 2mm thick cardboard. Can be orientated to any direction - can…
Wine bottle rack for fridge shelf which holds 2 bottles. The bottle rests with its top slightly high, which should avoid the spillage in the fridge in case the cap leaks. Update - 01 Apr 2024: re-exported the project file using ‘Generic…
A front-load rack for beer cans (440ml) that holds 8 cans. Direct access to any cans in the rack. Can store shorter cans (330ml) as well. The front end is slightly raised to avoid cans sliding out. Connect another EIGHT or FIVE rack on…
I printed using Bambu PETG Basic. No support. Update - 01 Apr 2024: re-exported the project file using ‘Generic 3MF’ from Bambu Studio as the previous version didn't open correctly for some editor. Updaet - 09 May 2024: improved the…
These are all currently available results.
