Counting matching models…
Printed okay with no supports. As macroglossum suggests, slight supports under the wings may be helpful but it still looks good. The 18.5mm hole for the magnet was added using tinkercad. It fits snugly but may require a bit of glue.
Triple G Workshop's wonderful Cthulu chip clip with an insert for a magnet (9.55mm diameter, 3.8mm depth) – applied heat from a soldering iron to insert the magnet. (forgot that the soldering iron was magnetic though and that complicated…
This is a fan-made Soul Coin for the 'Baldur's Gate: Descent Into Avernus' module by Dungeons and Dragons. It's based off the design they used for the coins they had minted and the concept art found within the module. The finished product…
Pasting Dave's original description here: Description Big, fun dreidel here! Simply glue the stem to the body (it should fit snugly in there so only a tiny tab is needed). Enjoy!
Pasting CodeCreations' original description below: Summary This is a metric hole test pattern that I developed years ago when I was doing more work with Shapeways. It is a flat, 3 millimeter thick piece with standard metric drill bit size…
Fun variation on SNASA's pencil holder design. Small tray for coins, soap, etc. Mine will be used for rolling dice. Like SNASA's original design, the finished print will be flexible.
print upside down with supports Note - it is a bit tight so I may end up scaling up the holder if it becomes annoying
These are all currently available results.
