Counting matching models…
This is a work in progress Printed it with ABS 60% infill to make sure it was solid enough to handle getting hit with a hammer. If printing on the seal side, which I did, I used organic supports.
Needed to create a holder for all the SnowJoe SunJoe batteries I have to better organize them.
I needed a holder for my black & decker cordless screw driver to hang on my honey comb wall. I created 3 different styles. One style is made to mount directly to a wall, in case you want to add it to a work bench. The other two styles are…
Needed a large alcohol bottle holder for a 32oz bottle you get from Walmart. Holder is made to be mounted on a honeycomb wall. Use supports to print
Created a sun glass holder with a spot to fit a post it note and 2 pens. I glued 2 magnets on the back which I purchased off of amazon, link below. Be careful they are very strong magnets. Glue one at a time and make sure the glue is…
Couldn't fit a paper towel holder on the honeycomb wall cause it was too big. Found that my wife's makeup remover pads work just as good and have a scrubbing side. So I began using this to clean off my print beds. Bought them from Target,…
Couldn't find a heat gun holder that fits my heat gun. It's a Seekone heat gun from amazon. Made to go with a honeycomb wall.
Needed a leg that was a little bit longer to better prop up the keyboard for gaming. So I made these legs. They are 33mm long and give the keyboard a better angle
I wanted something a little stronger around the screw holes, so I went with a little more infill. Then used a tap to make the threads. I used M2 screws for the Rasberry Pi 3 and M3 for the mosfet. Rafts: No Supports: No Resolution:. 2…
Corsair Capswap Zombie apocalypse
Miscellaneous magnetic locker holder for school. Holds 2 pens, a post it note, and a clip to hold whatever needs to be hung of importance. The magnets I used are very strong magnets that I purchased off of Amazon. They fit perfectly on…
These are all currently available results.
