P
Printablestkchan007
PTFE Cutter Gridfinity Bin
Another Gridfinity based organizer. This one is to hold my PTFE Tube Cutter.
- Downloads
- 330
- Likes
- 46
- Rating
- 4.71
All models
Counting matching models…
P
Printablestkchan007
FRC Radio and RSL Mount
A mount for the FRC Radio and the RSL Light. The mount can be screw mounted or strap mounted onto 2"x1" Aluminum Tube. The Radio can be held in place using zip ties across the 2x slots. This is so it'll be easier to remove to flash the…
- Downloads
- 262
- Likes
- 17
- Rating
- 4.5
P
Printablestkchan007
FRC 2x1 Aluminum Tube End Cap
TPU End Caps for 2x1 Aluminum Tube.
- Downloads
- 121
- Likes
- 5
- Rating
- 5
P
Printablestkchan007
Bambu X1C Poop Ramp - Left Size
My Bambu X1C is placed on a stand with a very tight spacing around it. I ended up deciding a quick poop ramp that redirects the poop to the left size over the stand's edge where I have a bucket under to catch them.
- Downloads
- 97
- Likes
- 18
- Rating
- 5
P
Printablestkchan007
FRC 0.5" Hex Shaft Hand Crank
Hand crank for those 0.5" Hex Shaft on FRC Robot. Print using 4x Walls, 25% infill (Gyroids or Honeycomb) on PLA+/ABS. You can up the walls to 6x if you are printing with just PLA.
- Downloads
- 58
- Likes
- 4
- Rating
- 0
P
Printablestkchan007
Creality CR-10 Smart Spool Holder Center Rod
Our CR-10 Smart's center rod for the Spool Holder has been broken since day 1. Since we've been printing straight out of the dryer, never had a need to replace it. Finally gotten the time to put the model into CAD to model it so I can…
- Downloads
- 26
- Likes
- 2
- Rating
- 0
P
Printablestkchan007
3D Printed Parts for a Compact Belt Driven Elevator for FRC
Components for the creation of a compact belt driven elevator primary using 3d printed parts with main frames made out of 1/8" thick 2x1" aluminum tubings. Components modified from OnShape CAD models.
- Downloads
- 22
- Likes
- 0
- Rating
- 0
P
Printablestkchan007
FRC 2x1 Tube Slider
Slider to be used with 2x1 Tubings for building of Elevator. Student's Off Season Project.
- Downloads
- 21
- Likes
- 2
- Rating
- 0
P
Printablestkchan007
Hirth Camera Carrier with ArduCam Case
Hirth Plate (1.5 teeth glue) is to be glued to the ArduCam Base Plate and HoriTop (plate). Depending on mounting/joint orientation, can hirth plate can be on the inside or outside. The Smaller ArduCam Case is then mounted on top of the…
- Downloads
- 19
- Likes
- 5
- Rating
- 0
These are all currently available results.