Counting matching models…
LM2596 Holder for DIN-Rails Category: Electronics Based on Models by Greg Cormier (https://www.thingiverse.com/enkoopa/designs), 3DPrintSOS(https://www.thingiverse.com/fedorsosnin/designs) and Jens Petersen…
Easy to print DIN rail Clips for WAGO 221-415. Based on OV1A's design. Made it wider to match the width of the 221-415 and added a section on top that acts as room for a label and as a lever for easier removal of the clamp from the Rail.…
Higher Feet for O11 Air Mini for improved Airflow. You need 1 set of mirrored and 1 set of regular feet each (Yes the long one is the same for mirrored and regular version ;) ).
Rocker feet for Van Rysel D500 Smart Trainer (V2)
Adapts the 120mm rails for 140mm fans
← This is in Beta → Extract those nasty soldering Fumes straight out the window. Uses a 120mmx25mm PC-Fan running at 12V (Needs an external 12V PSU) and a 100mm hose
Uses 6 3x2mm Magnets. The tolerances are a bit on the looser side, so if you have a well calibrated machine, pure friction won't be sufficient - use a bit of glue to keep them in place. ATTENTION: This has only been tested with my…
Very tight fit, you may have to stretch it a bit in x and y if it’s too tight.
These are all currently available results.
