Counting matching models…
This is a wider version of a scissoring mechanism designed by Richard Swika on thingiverse Print Settings Rafts: No Supports: No Resolution: 0.2 Infill: 30% pick material wisely, Pla may break at handle
bed cohesion is key here, especially for the tri-loop mesh
using an 8mm by 155mm steel rod going from base to finger tip this model is designed not to brake easily. brim: check model notes supports: yes in organic/tree if available layer hight: .2mm with .4mm nozzle infill: 15% gyroid material:…
designed in fusion 360, this 287 segment model was intended for amusement purpose though it doesn't have to be. warning this a some what obnoxious to print so probably use glue print speed: first layer 10mm/s or slower, other layers…
printed at 0.05mm in resin. may need some lube when installed
The reliability of these prints is heavily dependent on how clean your print bed is, keep that in mind. Print settings: a high z-hop is highly recommend 0.6mm< along with retraction ~2mm 0.2mm print works but could probably be smaller…
Printed with Overture TPU at 0.2mm, this design requires some support material on the outer tab of the model. High retraction is recommended.
printed on the Prusa mk3s+, this petg mount is made to sit on the top of the ender 3 v2s extruder case and to screw into its heatsink temperature: extruder all layers 240c, bed first layer 85 other layers 75c layer height: .2mm nozzle…
These are all currently available results.
