Counting matching models…
Version 4 added 8/13/25 but is untested. This is a simple valve spring compressor tool I designed for the M54/52 cylinder heads. I printed this in Overture PC on a Bambu Lab X1C in draft mode (0.28mm layer height) with 4 perimeters and…
This is an alternative to the expensive Ryobi Link rails. Obvious drawback is having mount and space individual cleats one a time, but also allows for more flexibility. I used these cleats on a sheet of OSB screwed to the wall studs,…
UPDATE 8/25/24: just tested a new print of this with 2 perimeters and 15% infill, and it wasn’t strong enough, 4 perimeters is necessary. UPDATE 4/24/24: Enlarged the square hole ratchet to 10mm, it was too tightly dimensioned at exactly…
A couple tool box trays to hold the metric Milwaukee Insider sockets. I found that the rail that comes with the sockets is too annoying to use. The newer socket adaptors that come with the spring loaded retention feature have to be…
Cupholder inserts that replace the foam inserts on the second generation Honda Odyssey (1999 - 2004). The old foam inserts can easily be ripped out but these inserts may fit with them in place. New foam inserts are still available from…
This is a prototype of cold air intake for the Smart 451 that deletes the intake resonator. It's modeled it to have a consistent internal diameter along it's length and a smooth route for the air to travel from the air filter box to the…
UPDATE (11/25/24): I just fitted it to the car as seen in the photo, its a very tight fit on the MAF and the air box lid, I took both of those off the car to be able to twist it on. The inside diameter is 70mm, I'm uploading a version…
This is cap that is meant to shield the belt pulley bearings from dust and moisture on the BMW M60 engines. I added the notches so that pliers could be used to remove the cap when needed. Original part number: 11281727159 Print in TPU for…
UPDATE: I found that the superglue gel didn't hold up for many drive cycles, maybe some sort of epoxy would be better. ----- This is a printable flange to replace the turbo inlet flange on the F30 which is usually crumbling and separated…
This is a bench top organizer for this kit that sells without a storage solution of its own: https://www.harborfreight.com/engine-brush-kit-20-piece-63732.html I found this kit on Amazon that looks to be from the same factory but comes…
This is for adapting the digital rearview cameras that are common on Amazon to late 90's and early 2000's Hondas. It requires destroying the original mirror to use its articulating stalk and removing the brackets off of the digital…
After 30 years and nearly 300,000 miles the dampener bushings on the belt tensioner on my 530iT were hard as a rock, crumbling and loose. The OEM replacement is now $250! Print these in TPU , I used Overture High Speed TPU on my Bambu A1…
I had Claude AI design these. 5mm through 24mm no skips! Useful for spinning fasteners in tight spaces where you can barely fit your hand or a power tool and have no option but to spin the socket with your fingertips. Often you can fit a…
This is a replacement bracket for one of the older Hunter Douglas blinds designs that are no longer available for sale or difficult to source. Print these on their side with automatic supports turned on. I used ASA because it is both…
These are all currently available results.
