Counting matching models…
Print in the orientation of the STL files with support. The support contact face is nearly non-functional and you will not touch it, therefore even some roughness at that surface doesn't matter. Be aware: OLED version is 3mm wider than…
After some adaption to my model for the original switch ( Nintendo Switch Grip for v1/v2/oled ) I am finally able to publish this one. Significant changes have been made, as the switch 2 is quite a big larger. The handles at the back were…
Used the two great resources ( https://www.thingiverse.com/thing:2990158 ) (thank you guys!) and adapted it a bit: 1) 1. Layer has a larger surface to allow better adhesion to the printingg surface 2) Supports are not needed. The supports…
This is my shot at an enclosure for the Prusa XL. All information needed is in the manual file provided under the files tab. Make sure to read trough the manual once before you start assembling. This will prevent work that has to be…
This part creats some tension on the metal side panels of the Original Prusa XL, which leads to less resonance on those while printing. Effectively reducing the rattle sounds on thos panels (only). If the part alone is not helping enough…
Hook to be used together with wildly used hooks on picture frames and mostly alu dibond picture. This hook is fixed on the wall with a screw for the picture hooks to slide into it. Benefits are: Easy print with low support only for the…
On the 1 or 2 head Original Pursa XL configuration, there are only 2 power supplies attached to the back panel of the printer. This part creats some tension on the metal panel, which leads to less resonance on those while printing.…
My take on a cute valentines day elephant. Thanks for the model Daniel Vaz (remixed) and Matthias L (original creator)! Printing information: Print the elephant and the trunk parts in hard material (PLA, PETG, …) Print the heart on the…
Upgrade for CABBY enclosure: https://www.printables.com/model/585697-cabby-enclosure-for-original-prusa-xl Upgrade to provide a possibility for additional magnets on the front doors, at the top of the doors. This is by no means a…
Used enrico_19's design but found out that the endstop switch was too far in the front for the screw to make good contact. With this one, the switch is mounted a bit backwards. Works with enrico_19's "Z-EndStop_XMotor.stl". Category: 3D…
Deckelhalter für Sodastream Flaschen. In elastischem Material (TPU) drucken. Infill so wählen, dass in den Ringen noch ein Hohlraum ist, damit ist dieser noch elastischer und das Anbringen kein Problem. Cap holder for Sodastream bottles.…
Ratchet clip for Shimano SH-ME301. After my original one broke, I made this one which works quite well. No support needed, as it is already included in the part itself. This part is for the right shoe. If you want it for the left one,…
A simple spool holder that can be screwed to the prusa i3 frame. Uses the same (M3) screws that are used to mount the straight z-axis-rod. Outer diameter 30mm. Category: 3D Printer Accessories
These are all currently available results.
