Counting matching models…
I wanted to bag a disc at tournaments that I made , so I started the process of designing a putter that was fairly stable, but could handle some anhyzer/flex. During the design process I realized the disc also floats in water pretty…
I needed to adjust my door strike plates due to house settling. Instead of filing away the metal ones that were previously installed, I decided to make the file which can be bent to match the door with a heat gun. A DXF file is included…
Flight numbers are ~ 5/3/0/3 I recommend printing in a firm TPU such as Overture HS TPU If you're looking for a PDGA approved disc, you may want to print my Cricket After getting the Cricket approved, I wanted to make a midrange, and…
The style labeled “Butterfly” is intended to mimic a floppy bow made with large pieces of fabric. The style labeled “bow” mimics a traditional ribbon style bow. SVGs were made and edited in Inkscape to have the “Negative modifier” leave…
I edited the original part to remove the bottom surface fillet so that the part can print without supports
The pattern and density of the grill is set by the infill of the cylinder in the slicer
These can work with any 18 gauge nail and a 1/4in or 6.75mm hose. I designed these to work with the Home Master Reverse Osmosis Refrigerator kit to go under the cabinets along the floor board.
A simple wall mount for using this USB battery charger when not in use
Kazmar's bearing: https://www.printables.com/model/587056-ptfe-tube-bearing-608 since the spool holders don't have much load, these PTFE bearings work great
These are all currently available results.
