Counting matching models…
I would recommend printing it in PETG for the temperature resistance, but PLA should be ok too if your car does not see much sunlight, a well-calibrated printer is recommended for better print quality.
A Shifter mount for the GT Omega Wheelstand, designed for the Thrustmaster TH8 but should also work for other shifters with table clamps, alternatively the model can be edited to punch some holes in case it should be bolted on. Disclaimer…
A Bin for your Jeep Xj's Cupholder, designed specifically to fit the back cupholder which doesnt actually hold a cup (unless its like, a really small one or something) Printed in PETG, PLA may work but i would not recommend it due to…
A set of very simple TPU feet for the Fractal Design North, designed to (barely) fit over the stock feet, depending on your printer calibration it may need to be scaled up slightly, especially when using PETG or PLA. When using TPU print…
A Rim/Wheel cover for the Hotwheels Brick Shop Honda NSX, built from the ground up™ for printing. Be aware, this print is VERY fragile, a 0.2mm nozzle is recommended! To print with a 0.4mm nozzle, set the layer height around 0.16mm and…
Replacement for the Bottom Piece of a cheap TEDI Bathroom shelf, the original piece broke when the suction cups failed so i quickly whipped up a replacement. It may be too long to print in one go, i split it in half and added 3…
These are all currently available results.
