Counting matching models…
Made to hold a Rode VideoMicro. I used support and printed on PLA. Support was a bit hard to remove but still works. Printed on Makerbot Sketch using Jessie PLA Temp was 235c and 60c Layer height was 0.15 Infill 15% Breakaway 40min print…
I made this bridge so Sphero Indi can drive over and under without issue. I also made it so that it can be taken apart and take up less space when stored. Use Scotch tape or white Masking tape to hold the pieces together. The legs and…
Printed on Creality K1 Max. I pause before the print before it finishes so I can add washers. I was able to fit 9 washers. 3 washers on each side. The washer will make the mouse stop. The washers that I used are 1/8 inch X 1 inch zinc…
These are all currently available results.
