Counting matching models…
Printing instructions .4mm nozzle layer height 0.2mm Walls 4, 0 TOP and 0 BOTTOM Layers. Infill honeycomb and percentage of 18-28 higher infil gives better effect but darker image through lens. Can be lightly painted. Fit should be snug…
Printed in TPU, tight fit over device and can be fired off if desired, will destroy it though. Use them for storage in places not controlled with humitidy or temperature to keep crap out of bore.
Killflash for the fossdot, replaces 1 part the lens holder with 2 a modified lens holder and a press fit killflash. Project file shows how to do object modifier, object modifier has 0 walls, 0 top and bottom layers. Honeycomb infil with…
For stronger thing i printed at 45 degrees used pla with 100% infill and kids slamming the gate havent been able to break it yet unlike the original plastic one. Even lines up with the old screw holes on the wall.
Rubber stoppers on my excursion were trash so i designed this "plug" looking thing to get the stance of the fuel door correct again. Printed in TPU with few walls and low infil time will tell but pops into place and holding up well now…
These are all currently available results.
