Counting matching models…
I’ve had an external HD connected to my upright PS5 for a while, and it’s always bothered me how precarious the connection was - it either had to be sitting on the floor, or draped over the top. As you know, if the HD disconnects while…
When I go skiing, I always am nervous pulling my phone out on the chairlift, worrying that even though I'm gripping it as hard as I possibly can… a bump on the ride is going to cause me to drop it. If I had even the slightest sense of…
Simple under-desk mount for this excellent charging brick
Could I have found someone else's design for something like this? Sure. Printed with Carbon Fiber blend PETG. Brim, 20% infill and 4 perimeters.
See my updated compact version , best for 1 pair of skis. I kept getting ads for “SnoStrips” , a kind of unecessary way to keep your skis upright when getting dressed before hitting the slopes. “$50?!” I thought - “I could make that.” And…
Quick and dirty under-desk mount for the power brick that accompanies the beautiful LG 38WN95C-W. Printed with PLA and supports under the screw tabs.
A remix of the amazing Magsafe charger stand to make it longer & allow my oura ring charger to sit nicely on the base.
I love my Oura ring as well as the charging mechanism, however, because the ring sits in the cradle only using gravity, it can fall out if the charger isn't on a flat surface. This model wraps the charger and holds the ring in place,…
This CD mount for the Spotify Car Thing raises the device up and to the left, to avoid the car's radio LCD. Assembly Instructions Unscrew the adapter disk from the CD Mount with a Torx bit. Be careful not to lose this screw. Place adapter…
An improvement to my original model . I kept getting ads for “SnoStrips” , a kind of unecessary way to keep your skis upright when getting dressed before hitting the slopes. “$50?!” I thought - “I could make that.” And so I did. Been…
Deepened the Oura Ring charger depression so it sits flush with the surface of the base. Entirely unnecessary, but hey it’s mine.
Produce in our fridge kept freezing at the bottom of the drawer, even after adjusting temps, so I designed a set of trays/racks to slightly elevate the food off the coldest part of the drawer. The legs are shaped for the raised beds…
Simple, does the trick. Needed a spot to put my kindle next to my bad. Designed this, used double-sided 3M tape to stick to the side of my bedside table. PLA is fine, 15% infill, 4 perimeters. Used fuzzy skin, looks good.
A remix of the excellent Prusa Mini USB Mod V2 , that accommodates USA available USB cord products on Amazon. My remix includes a wider birth for the female USB end and a wider stopper to keep the end in place. Here is the best USB cord…
My father In-Law showed me a set of old curtains at their house, and mentioned that the style is very old, and that the custom plastic pins needed to hand curtains on them have been discontinued, and are very difficult to get. Using one…
I needed to get my right Bose speaker off my desk surface, and so I designed a monitor mount post clamp & arm to elevate & cradle the speaker so it sits above my right oriented laptop. Incredibly specific for my needs, but if you have…
Needed a place for a cocktail glass near the grill. PETG with organic supports.
Sometimes, when leaving my house, I don't want to walk my EV plug all the way forward to the place it's plugged in / where I have a hook. Often, I just want to chuck it on the ground / in the garden so it's in reach when I re-park. This…
As a tall guy & a beginner, I've got a giant 9' foam board. I also have a small garage and a wife who loves staying organized. I designed this bracket to be printed 4 times, and and then have some narrow rope strung through pairs to…
These are all currently available results.
