Counting matching models…
After searching for a bit, I didn't find a mug holder model that fit my favorite mug 'just right' so I did what any of us would do... right? I've printed two thus far. One in PETG with magnets and and another in PLA I printed with "Fuzzy…
I didn't like the exposed end of the 4040 extrusion after doing the EnderExtender upgrade so I made this piece just to clean up the esthetics a bit. No new hardware is required, you can use existing leftover screws.
Printable bracket for mounting a US-8-150W in a 19" rack. FYI, some would consider my print settings excessive. No supports are required, but I print with them anyway… Filament: PETG Walls: 4 Infill: 40% Top/Bottom Solid Layers: 5 202609…
I got some flashlights compatible with 18650 batteries but the battery would sit crooked. It caused some intermittent connection issues. ~30 minutes of modeling, problem solved. Modeled in 55mm & 61.5mm lengths. https://a360.co/3VaizVz
I needed a extension to position my favorite coffee cup in the single cup brewer to prevent excessive splashing.
This is for the Ender Extender 400 AC Powered 600 watt heat pad : I wanted to make sure the AC heat pad was centered as close to perfectly as possible. So I created this simple-to-print guide pin that fits over the build plate screws. Two…
Needed a basic wall mount solution for 8 of the Retevis RB17 FRS radios. The mount allows access to the rear USB-C port as well as visibility of the charging indicator LED.
Needed a storage solution that meets a few requirements: 1) Cheap 2) Wall mount 3) Each drawer/tray needed to be at least ~4/5/5in (~100/125/125mm) I found a solution at Harbor Freight that met 2 of 3.…
These are all currently available results.
