Counting matching models…
Center-bar chain, also known as non-fouling anchor chain. I noticed there was no models for it so I made as large a piece as would fit diagonally on my printer bed. I've printed it full-size and at 75% reduction. Both worked fine. Print…
Just a pad that helps seat the AR15's stock against your shoulder... Slips easily on the Brownell MilSpec and stays put. This makes standing shoulder firing so much more pleasant. The diamond-check pattern on the OE stock is downright…
One top per stack and as many slots as you feel like stacking. Stands up well until there's about eight of them, then it falls over backward... This organizer fits the wider white trays that are included with some diamond art kits. Unlike…
My GF and I worked on this design for a while before she was satisfied that this was the final iteration. It's a relatively compact diamond painting tray organizer. Print four trays and one top, one buttress. If you find the slots are too…
This is just a knob to replace your lost lights control knob in your Chevy truck. There are several versions. Check the 3D viewer of the STL to make sure you've selected the one with the appropriate length and detent for your control…
Like 608 bearings? Like 8mm threaded rod? Tired of universal spool holders that use stepping that almost, but not quite, fits your spools? This should fit nearly any spool between 35 and 60mm ID and uses a 608 bearing as the hub. Print…
Yet another 3D Solutech spool adapter, this time optimized for the ubiquitous 608 bearing! Should print fine without support, but if you have droopy filament, might want to enable it for the 90 degree overhang on the inner lip. Category:…
This will allow you to throw out the fake “all-metal” hotend on your Sovol or Creality direct-drive and install an E3D V6 or REVO6 on the carriage using a Titan extruder. This might work with the Creality extruder, I wouldn't know. I…
I couldn't find an allen wrench big enough in my tool set, so I just printed a hexagonal prism long enough to get a socket on it. Worked well for me with an 11mm socket. Let me know how this works for you. I printed it laying on it's side…
This is an effector for 50mm arm spread deltas that will carry a 30mm fan and an E3D V6 hotend. Use a material besides basic PLA. The higher temps it can take, the better.
If you have Circulon Pro cookware and want to store the lids vertically, here you go. The numbers in the file names indicate which diameter lid they are for. I can easily model another diameter if you should need it, but if they don't fit…
It's just a simple clip, intended to be screwed to an overhead beam, that holds the cables for lantern-style stringlights without subjecting them to significant stresses.
Toyota was nice enough to make a clutch slave cylinder that is almost impossible to secure with a clamp. Even if you do manage to get a c-clamp to fit, it's precarious and clunky and, since you have to move the slave cylinder assembly out…
These are all currently available results.
