Counting matching models…
Upgraded to the QR2 for my two wheels and wanted a wall mount. Due to the tapered fit and poka-yoke design of the QR2 I didn't find any available models would allow the wheel side to lock on. This design should be quite forgiving printer…
PLEASE POST YOUR MAKES! So I love my little PS90. The trigger was not to my liking so I ordered a K&M Trigger Pack Spring and the P*****d Pawn Creep Killer II (unmodified hammer version). I wouldn't normally freely release something…
Got a lightly used Mobula7 1s ELRS version with 8 BetaFPV 450mah batteries BT2.0 connector for a deal. Flew it about 8 times using the battery lead in tensions (connector at the front) to keep the battery from coming out but a high speed…
I've had the Quest Pro controllers since their first release, using them on a Quest 2 and now a Quest 3. Always having lay the puck and controllers down on a table surface has annoyed me. Thank you to Bengyboo for the simple headset wall…
I refuse to blow hot air into my case and needed room for a 13.5" 4090 GPU to fit in my Fractal North Case. Printed in PETG for the Plastite Fan screws This requires: the front case fans to be mounted outboard of their mounting position…
Scope Cap for Objective end of Scope. Specifically fits Customized model for the Zeis LRP S3 6-36x 56mm models.
Scope Cap for Objective end of Scope. Specifically fits Customized model for the Athlon Optics Ares ETR 4.5-30X 56mm.
Working towards mounting all the electronics minus the steppers outside of the enclosure to allow the eventual printing of higher temp materials. Next up will be finding extension jumpers for all the Einsy board connections and mounting…
Print mounts with M4 nuts embedded in part: Pause print at last layer full hex is visible in slicer preview and insert nuts into print, then resume print. Used M4 x 8mm SS screws with M4 fender washers and then 1/4" Fender washers to…
This is a remix of a remix (Original Clough42 converted to Schmitzna collet guided tungsten without a vacuum port). I have a WP-20 torch and wanted this design to use the smaller 0.154" Diameter collets (vs Schmitzna larger .22" OD…
I wanted to use a female - female duttek 90 deg connector as I'll have an extra from the gopro P2 Pro case.
Got tired of forgetting my hold overs so invested in the DRS E-Dope card and keeping all my DOPE digitally. Design: 1) Mounts via 1913 Picatinny Rail 2) Quick Magnetic Attach / Detach (so card can be transferred to multiple pew tubes) 3)…
Remix where I added embossed size labels for .040, 1/16, 3/32, and 1/8
Acquired a WolfBox MF100 extremely powerful air duster based on Project Farm's Youtube review and was not disappointed. Luckily when not in TURBO mode it will stay on indefinitely in its low and Medium settings which is still alot of air.…
Was looking for a parallax wheel for my new scope and didn't find it. Used 1x M2x10mm SHCS and 1x M2 Nut to clamp down. Printed in Prusament PC Blend (in PLA it printed perfectly at 100%, for the PC I needed to scale up to 101% to fit…
Dual Banding night vision puts a lot of weight on your for head and needs a ballast weight on the back to balance the load. Currently using a AOUTACC bump helmet but will receive my real ballistics helmet soon. Fits the curve of the…
These are all currently available results.
