All models

3 models

Remade for filament swap- Christmas door Corner

Umm so I went a bit over board. Was just going to make the hat higher so I could swap to red. Then I just kept going. End result is all the parts separated. So you can do the color change on any part you want. Or print them all…

Downloads: 94
Likes: 24
Rating: 0

Order a print of this model

PrintablesAggro Magnet

X-plus Qidi side panel replacement

The original was oddly not flat. This is a flat on top and bottom. Added my fun cut out venting for PLA printing.

Downloads: 44
Likes: 1
Rating: 0

Order a print of this model

PrintablesAggro Magnet

Filled in the space

Filled in the space to make it ready for a filament swap. Also thinned out the original from 4mm to 2mm. The base is 1mm thick. I have up loaded both pieces as well as .obj so you can change those as works best for you. Thinkercad is the…

Downloads: 35
Likes: 2
Rating: 0

Order a print of this model

These are all currently available results.