Counting matching models…
This mount is designed to hold and protect the HDZero freestyle VTX antenna. It is available in 2 versions : 1 for Heks Joocy frame 1 for BLS Forza frame The standoffs should be M3 size with a diameter of 5mm. The antenna is inclined at a…
Radiomaster RP1 rx holder for a 20x20 mount. The receiver is tightened with a zip tie that passes through the two notches. Additionally, there is a hole through the support to allow for the passage of an antenna wire.
This folding TPU mount is designed to attach the Radiomaster RP1 antenna onto the standoffs of your kwad. The required standoffs for these mounts should be M3 size with a diameter of 5mm. This design was inspired by @Haku3D, and since I…
This mount is primarily designed to be used with the Heks Joocy frame, but it may also be compatible with other frames. The capacitor should be a panasonic 1000µF 35V. The standoffs required for this mount should have an M3 size with a…
A mount to hold a 470µF capacitor on an XT60 connector. It may not fit all capacitors, the diameter is 10.5mm. Print it in TPU to absorb shocks.
Universal GoPro mount for the BLS Forza frame. It is slightly shorter than the top plate in order to add tension to the TPU with the screws to avoid too much vibration.
This BLS Forza camera mount is designed to replace the camera plates of the frame. The tilt of the camera can go from 20 to 50 degrees. It is specifically designed to be used with 28mm height standoffs and exist in 2 versions : 14mm to…
These are all currently available results.
