LayersFactory

All models

Sort order

Counting matching models…

P
Printablesdrewmoseley

ESP32 D1 Mini Case Bottom with Pin Access

Just a slightly modified version that adds GPIO pin access.

Downloads
182
Likes
17
Rating
3.5
Order a print of this model
P
Printablesdrewmoseley

Improved Wandering Hour Clock - Modifications

These are slightly modified parts for the wandering hour clock. I made the Numberwheels a bit thicker and enlarged the hole for a heatset insert. The screws I was originally using poked through the front of the original parts so I made…

Downloads
164
Likes
52
Rating
0
Order a print of this model
P
Printablesdrewmoseley

Unfolding James Webb Space Telescope (JWST) Sunshield Template

I had trouble making the sunshield from the descriptions in the other models. I created this as a template that can be glued in place using either Elmer's Glue or CA Glue. The spars can then be cut off with a pair of wire cutters and you…

Downloads
94
Likes
17
Rating
5
Order a print of this model
P
Printablesdrewmoseley

Sovol SV04 Springsteel Sheet Bed Alignment Tabs

Bed alignment tabs for the Sovol SV04.

Downloads
60
Likes
10
Rating
0
Order a print of this model
P
Printablesdrewmoseley

Slim Raspberry Pi Zero WH / Zero 2 W Base with SDCard holder

I wanted some slots to hold a few extra SDCards. Supports may be needed depending on your printer.

Downloads
42
Likes
11
Rating
0
Order a print of this model
P
Printablesdrewmoseley

ESP8266 D1 Mini Case Pins Exposed

This is a simple case for a Wavgat branch D1-Mini. I could not find one that fit this specific board with the pins exposed so I created this.

Downloads
34
Likes
1
Rating
5
Order a print of this model
P
Printablesdrewmoseley

ESP-F Devkit V4 Case - Pins Exposed

This is a pretty simple build. You may need to enable “Print Thin Walls” or whatever the appropriate setting is in your slicer.

Downloads
31
Likes
3
Rating
0
Order a print of this model
P
Printablesdrewmoseley

ESP32 DevKitC Case Lid with Antenna

Just added a short hole to allow the wifi antenna through.

Downloads
23
Likes
2
Rating
0
Order a print of this model
P
Printablesdrewmoseley

Sunlu S1 Filament dryer mount for RepRack - Modified

I used a wood french cleat across the entire width of my Reprack and needed a bit more clearance on the back.

Downloads
21
Likes
9
Rating
5
Order a print of this model
P
Printablesdrewmoseley

Yubikey Keychain Sleeve

This is a modified bottom piece adding a cutout for a 19mm x 6mm x 2mm bar magnet.

Downloads
12
Likes
1
Rating
0
Order a print of this model

These are all currently available results.