Counting matching models…
To make this, you'll need to print one stem, one pot, and three petals. The pedals and stem will need support material. Once printed, no glue is necessary. They should be able to easily snap into place securely. The stem may need a bit of…
This is a cable organizer primarily designed for USB cables. Other types of cables may not fit properly. You can use this in any spot where you keep extra cables. That could be in a bin, a drawer, or even your glovebox. Additionally, this…
I made this as a nice case to hold my school ID (I took it out for the photo) that I'm required to wear every day. I made a vertical and horizontal that you can use based off personal preference. If the tolerance is too tight for your…
Use this to test and dial in various bridging settings.
This remix cuts out material to provide enough clearance to use both the PCB mount and the cutter arm on the same unit. Because the top hole on the PCB mount isn't complete, make sure not to overtighten. I also recommend using an m3…
I recommend printing in ABS due to heat from the neo 550 motor. This is a remix of a neo 550 motor cover by Jonathank26. All I did was add some cooling holes so that the motor doesn't overheat. *update: I made the holes circular so that…
*Before Printing make sure your power supply is about 47 x 106 x 28mm * Tired of stuffing what feels like a mile long cable into your computer bag? This wrap can help you keep you bag, or backpack nice and tidy. About the Print: No…
I used #9 x 3in wood screws. This gives a bit less that 1/2in of thread contact. I recommend using the included drill guide with a 1/8in (3.2mm) drill bit to make pilot holes. I've included step files for modification. You can also edit…
These are all currently available results.
