Counting matching models…
This is to rest the Saturn 2 vat that will protect the FEP. This makes it easy to clean or just get out of the way. There are two versions - fancy and simple. The fancy has some raised corners to hold the vat a little better.
This is a combat riser to be used with 28mm minis to show elevation differences between characters. It can go up to to 990 feet... even if you won't help your party too much while up there. It can be a bit top heavy, so I left room in the…
You can use these in or out of an existing condition ring holder or on their own. These fit perfectly in this D&D Condition Markers . The cut corners can go in any slot, but the the non cut corner ones can only go in the middle. I also…
This is a holder for the turntable that comes with the Elegoo Mercury Plus V3.0 Wash and Cure Station. You can tuck it either on the side or the back. I printed with supports, but you may not need them. I used 15% infill with 4 walls and…
This is a housing for a pump. I created this so I could move isopropyl alcohol from a container to a filter set-up This contains: 12V Barrel Jack DC Motor Controller Peristatic pump On/off Switch The switch is optional since the motor…
I had a small project and had a 276-159B proto board lying around, so I made a box for it. This project box can fit a MOSFET standing straight up. I designed it to have risers on the bottom to keep it steady in the box. I also added cable…
This is a remix of this . However, instead of housing the camera and a Raspberry Pi Zero, it just holds the camera and has a slot for the cable. Other arms can be created for other printers or situations. The short arm bar is barely out…
This is a grate designed to fit in a 125mm beaker dish. It gives clearance above the magnetic stirrer
I had questions about getting the correct angle to reduce the horizontal lines caused by pixel shift. We all know about arctan(layer height/pixelwidth) to find the ideal angle. For a Mars 2 (pixel width is 0.05mm) with a layer height of…
This is a grate designed to fit in a 150mm crystalizing dish. It gives clearance above the magnetic stirrer
My wife uses Lush brand things and I thought it'd be nice to store these upside down so that she could get the last little bit of the bottle. These work great. There are two variations - snug and loose. Snug interferes a little with the…
I disconnected a dryer outlet in my house and to remind myself to never use it, I made this plug.
When I replaced the fan in our bedroom, I now no longer needed the two switches that had controlled it since the fan came with a remote. So I made a mount for it that would replace one of the switches. There are two face plate fillers -…
I affectionately call this the bean protector. It was designed to fit a 150mm crystalizing dish to cover the magnetic stirrer. There are two versions, The second version with extra protection did not print well (the cage was too small and…
This is a stand for an 8.5" Econolite traffic light
Econolite 12" Reflector Holder
This tube holder is an accessory for Peristaltic Pump Housing . It holds the tube so it doesn't go in to the dirty stuff of decanted iso.
These are all currently available results.
