Counting matching models…
I modified @Duane's model to use two of the common 608 skateboard type bearing (7 x 22mm) and also an M4 screw to hold it together as that's what I had to hand. I used a paper clip and some glue to create the guide on the front.
This is a simple box that slides apart. I printed it on a prusa mini with a 0.6mm nozzle. It fits A6 notebooks, card or photos.
This is a simple housing for the esp32-1732S019 display, this case centers the display. Printed with a 0.6 nozzle. Accommodates both buttons. The lid snaps to the base model.
Printed with 0.6mm nozzle 0.35 layer height. Designed for 75 x 75mm post-it sticky notes.
Two parts, one screws to the bottom of a standard 3.5" disk and the other screws to a wall. You can then slide the hard drive onto the wall mount. I printed mine with a 0.6mm nozzle and PETG but it should work with any set up. It's small…
Replace both feet even if only one is needed to ensure they match. There is overhang but it prints fine on a prusa mini with stock settings. This model doesn't have the two step feature the original part has. You could make it shorter to…
I printed these and then glued ice cream sticks or popsicle or ice lolly sticks to them to create a wooden finish like the Fractal North case. Cut sticks to 85mm.
Fractal North Pi Side Panels with holes for GPIO + Camera. Print in orientations shown with brim. Layer lines will align with the rest of the case. No supports needed.
Case for S3 Mini Pro. Printed with a 0.6 nozzle 0.30mm layer height.
It has some percent of a mm shaved off the top and bottom so it slots in easier. Printing with a 0.6mm nozzle the IO port was bending to fit it. For the Pi 3 you can just mirror this part.
These are all currently available results.
