Counting matching models…
Low profile feet for Philips TV. Works perfectly with my Philips 49 inch LED 49PFT4132. You will need a total of 4 M4 screws and 2 prints of this model. Please note: this print will support your quite expensive TV. It is smaller than…
Print in 100% infill. Works well. Good fit. Use it to cover Kensington Lock port on your laptop or monitor. Category: Computer
December 2020 - TESTED, works fine! 10 Oct 2020 - UNTESTED, waiting for review Box fits 8 12.5mm SEM stubs. External dimensions 80mm x 40mm Category: Learning
Tight fit lens cap for Cisco P60 Camera. This design is inno way endorsed or approved by Cisco. This is a prototype, supplied without warranty and as-is. Use at your own risk. Category: Camera
Cubicle wall compatible toy. Tested, works well. Use supports just for the two topmost hooks. Very easy to remove. Print in grey for best effect. Category: Decor
Allows mounting a v-slot rail directly on a surface without raising it. Used it for my TeVo Tarantula when mounting to a LACK table. Category: 3D Printer Parts
Original design of a standard SEM cryo grid holder. Holds seven pieces. Tested printed in PLA, 100% infill, 0.2mm nozzle. Should work with SLA as well. Category: Physics & Astronomy
Basic set of hooks for flipchart paper. Intended to be either glued or double-taped to wall/fridge/whatever. Fits holes with 60mm spacing. Stubs have 20mm diameter and small retention tabs. Fits up to 10mm thick blocks of paper. Category:…
Adapter for LEGO wheels or gears. Allows connecting Pololu 1999 adapter to 6-hole LEGO wheels. Requires six M3 x 10mm screws. Should allow for press-fitting to LEGO bricks. Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No…
One-piece adapter for moneagle screen to gopro mount. Tested with PLA, works great with any tx16s gopro mount or other gopro accesssories. Category: R/C Vehicles
As in the title. Works well. Enough holes for LEDs, and power/reset buttons. Cutouts for ports and power. Compatible with the standard heatsink. Category: Computer
Extension to dexer's Door latch rising the latch by 14mm to account for my door shape. Fits M4 nut from below, may be screwed-in as the original design or act as a double-sided-taped plate with the M4 nut - does not put holes in your…
Remix of @petrilli https://www.printables.com/model/815721-holder-for-stm32-nucleo-f411re-board Heat inserts are not required, you just screw the M3 into the print. 2.8mm diameter hole works well on Prusa printers.
These are all currently available results.
