Counting matching models…
(Description from original author) WARNING The webcam application gets the board too hot for PLA even with the heat sink. I haven't seen it obviously deform but in my case the snap fit stopped working. You'll need to use PETG (and the…
I printed in PLA with 50% infill. It seems to be holding up fine, but I'd recommend either something a bit less flexible, or 100% infill. The arm length can be adjusted in the fusion file by going into User Parameters (Modify/Change…
A simple tri-glide slide. The Fusion file uses User Parameters to specify the internal hole size to create the slide size.
Just a simple Wyze v4 (Maybe others?) camera mount, with a 30mm riser to see above the bed. I didn't have any bar magnets handy, so used some 20mm round magnets. I'm assuming that you're keeping the adjustment legs on the camera so you…
I felt the Anycubic Air Purifier carbon section was pretty meager in its capacity, so I enlarged it. I also made it to hold carbon pellets, instead of needing to rely on proprietary filters.
Just a box to hold your carbon filter pellets Hole diameter is about 2mm, so most pellets should work. Print with something that'll hold up to the temperatures, of course.
Just a box to hold your carbon filter pellets Hole diameter is about 2mm, so most pellets should work. Print with something that'll hold up to the temperatures, of course.
Basically a remake of RepRack's Filament Shelf, but with 2020 Aluminum Extrusion. Choose either the over shelf bracket (bracket can act as book end), or the under shelf bracket to give more room on the shelf, depending on preferred style.…
I wanted a much simpler option for removing humidity from my Sunlu Dehumidifier than what was currently out there. I opted to use a USB 40x10 fan, with speed control. Something like…
These are all currently available results.
