Counting matching models…
This is a tool to assist in the migration of a Cisco or Meraki switch with a new Cisco or Meraki Switch. You would move the existing cables from the old switch to the tool allowing you to keep the cables in the same port locations. Then…
The original cable chains for the Wanhao I3 are very small and impossible to pull the servo leads through without disassembling the connector. So I switched to a 10x15 cable chain with small doors on each link that makes routing cables a…
This is a top and bottom plate for a DX Command Expedition Mast. They are intended to make field deployment of an antenna using this mast a bit easier. This should be printed in ASA or at the very least ABS. Carbon fiber PET or PC should…
This is a remix of https://www.thingiverse.com/thing:4909602 . I have modified it to use the 5x4x3 Heatset Inserts used in the Voron builds. I made the base 0.5mm thicker so you can use an M3x6 screw to assemble it with. update12/22/21…
This is a remix of several parts to mount a Hemera on a Voron Switchwire. I have abandonded this project and preset it as is. There will be no further changes. Print Settings Rafts: No Supports: No Resolution: 200 Infill: 20 Filament:…
This is an all in one FPV mount for the Nano Skyhunter, it might work on other planes. It is designed for a standard HS1177 FPV camera, a Matek VTX-HV, including a mount for the SMA bulkhead that comes with the VTX. I glued it to the deck…
I have designed a version of the Hero Me Base Gen2d, from scratch, in Fusion 360. It is a very close replica of the Gen2d. Thank you MediaMan, and Kelokera, for all your work on the original design. Pulling measurements off of the STL…
Using my Fusion 360 refresh of the Hero Me Base I have created a refresh of the Teaching Techs remix of the original Hero Me Base, but using the Gen2d design, for use with the DD E3 Direct Drive mount from Basaraba Innovations. Thanks…
This is a battery strap plate for bottom mounting batteries on the Floss two frame. It will also work on other quads with a flat bottom. Print using a flexible material like TPE or Ninja Flex. TPU will due but has issues in cold weather.…
This is a spacer that goes below the 4-in-1 esc. It replaces the thin, clear, plastic washers which do not effectively prevent the bottom of the esc from touching the carbon frame. The spacer goes over the four bottom screws and also…
This is a Fin for the Floss 2.1. I want to give credit to Serge for the great idea about using left over zip tie to secure the part. This fin has a hook that catches the front part of the top plate and tabs that helps catch the center…
These are all currently available results.
