Counting matching models…
Tool holder for the SV04. Modified the mount to fit the SV04 because how close the bed is to the screen. Adjusted the wrench slots. Sliced using Cura. Load the Tool holder and the Letters. Assign an extruder to each, highlight both, right…
Tire mounts using a 3mm machine screw. Self-tapping. I used a 3mm x 5mm machine screw
TPU wheel and PLA hub w/bearing. Designed and used on an Eflite Night visionaire, but should work on any 3mm wire landing gear. Uses these bearings ( uxcell F623ZZ Flanged Ball Bearing 3x10x4mm Shielded Chrome Steel Bearings 10pcs:…
Adapter for a craftsman shop vac to a floor sweep. Floor sweep is 2 ½" (od) to craftsman 2" hose. Adapter goes over vac hose and inside floor sweep, so actual size is approximately 45mm for the hose and 58 mm for the sweep side. Floor…
I moved my spool holder to the top of my CR6, because I upgraded to Direct Drive. When using TPU, I noticed that the filament did not feed very well on the stock spool holder. I designed and printed this one, and it is working great so…
Case and mount for the BTT TFT35 V3, for use on the Creality CR6-SE. There two mounts included, one for the left side of the printer, and one for the right side. For use with the BTT SKR CR6 aftermarket motherboard. 2-28-21 -Edit:…
Replacement Wing Fence for the FMS Avanti S. OEM replacements usually show up warped, they are made of some sort of fiber board. Print with PETG, so you don't have to worry about direct sunshine in the summer months. Stock one weighs 11…
Landing wheel for Conscendo Evolution. Plane has a plastic skid, landing on a hard surface wears it out pretty fast, so I designed this replacement. It takes the place of the stock skid. I am pretty sure that the same skid is used on the…
Simple mount for a Spektrum AR636. Secure the RX using a small piece of double sided tape. You will need to rotate the model in your slicer, so the base is flat. Print Settings Printer Brand: Creality Printer: Ender 3 Pro Rafts: Doesn't…
Couldn't find a wall mount that worked with my Arrma Granite 223s. Wanted something that I could stud mount using two screws. Also included extra holes in case you want to use plastic wall anchors, as the truck is heavy. I used 2 wood…
These are all currently available results.
