Counting matching models…
This model is a very compact motor-reducer, with precise movement and without backlash. The overall height is 29mm, only 6mm more than the motor shaft. The reduction ratio is (1 + 38/14) : 1 , roughly 3.7 : 1 Print instructions The model…
The magnetic aperture uses a pair of small cylindrical magnets diameter 3mm, height 3mm. The hinge pin can be made with a piece of hammered iron/copper/brass wire, 1mm diameter. You can glue a real wood veneer to the upper and bottom…
Small pyramids to support the piece to be painted.
if the screw breaks you have to change the whole stick, or use this spare part. The screw is tapered, so it should fit all brands.
Print with 0 bottom layers 0 top layers honeycomb infill 4 perimeters
Compared to classic wall attachments, this allows the motor housing to be stored parallel to the wall. In this way the total thickness does not exceed 13.5cm (which is more or less the diameter of the motor). The attachment incorporates a…
Suitable for 32mm tube. Use two to firmly fix the umbrella to the balcony wall. Print instructions Preferably use PETG which is better resistant to UV rays. Print lying down for maximum strength.
Print IN PETG with the front hole resting on the build plate.
Print with PEGT, which is more flexible than PLA, with 4 or 5 perimeters for maximum strength.
Tool holder crown, more robust than the original. The motor shaft is 5mm, but the hole in the piece is 4.8mm to ensure a good press fit. Print it vertically, with the face facing the motor on the build plate. No supports needed.
timer selector for Samsung GW71E microwave oven and similar models. More robust than the original. Print in PETG or PLA, without supports, with 3 perimeters for greater strength.
The plastic cap, known as the ferrule, is located at the top end of the paired ribs of big umbrellas. These double ribs, which run parallel to each other, provide additional strength and stability to the umbrella's frame. The fabric is…
Print with the wider face resting on the print bed. Insert a pause during printing to place the M3 nut inside
Spare pin for shutters, with or without metal core. For greater strength print the version with the hole and insert a metal pin 6mm diameter, 27mm long.
Print in PETG, because is slightly flexible, 100% infill. Place the flat side on the build plate.
This is a small and simple part, but vital for the correct functioning of the appliance. it is positioned at the rear, at the bottom. With time and limescale, the original piece can be damaged and the overflow probe no longer works…
These are all currently available results.
