9 models
I was tired of losing a little bit of powder when it balls up and falls out of my reagent satchets. This print works well so far, although I'd like to try sanding the inner funnel portion, vapor smooth it or print it in SLA for further…
360 degree wheel. Bolts onto either the harmonic balancer in car of a 4G63 or the crank sprocket using the harmonic balancer bolts. To install, attatch the hub to the car, then slide up the wheel and align it to the hub. Using 2 interior…
Print the centre section in 100% infill or all walls for some weight. Make sure your printer is accurately scaled (I run 100.32% to ensure accurate sizes at room temp with my PETG). No supports needed. Print both objects upside down…
Printed in PETG @ .2 layer height, can print with really whatever settings you want. Make sure it's at least a few perimeters for strength. PETG helps with flexibility to snap it over the edge of the aquarium.
Replacement knob for the fuel selector on many 2-Stroke Seadoo models. There are 2 models, one is a shorter version without the need for supports and a longer version modeled closer to factory. Both work fine, just personal preference.…
Speaker ring. Sized for stock screws into the door plate and #8 for the speaker. Made for Morel 602's. I am sure it would fit other speakers fine, but I did not have any to test. Only has 4 holes for mounting (it holds speakers at an…
Lid of Eshopps medium overflow. Fits well. Printed in PETG at .2 layer height, no supports required.
After removing existing grips, unscrew bolt in bar end, remove washer from bolt and reinstall through bar extender and install new grips per manufacturer. Can be cut to length in slicer as needed, 30mm extension in the file. Printed with…
My acrylic lid bowed and eventually cracked so I modeled this. Printed in PETG .2 Layer height.
These are all currently available results.
