Counting matching models…
This clip was actually perfect except for the fact that I would like to have small teeth on it, this model already existed and was printed by me several times. However, I print quite quickly and in my case especially, because I usually…
Here I have constructed a simple finger guard for 5015 fans. It was more for practice, but I think the result is quite useful and i would like to share it. Two versions are available, a simple thin one and a slightly more stable…
Here I have designed a small food bowl for rodents, for example, with a basic size of 80 mm inside diameter and a height of about 20 mm. Due to the various curves, the exact measurements vary, but I don't think that's so important for the…
Here I have constructed a simple finger guard for 40 mm fans. It was more for practice, but I think the result is quite useful and would like to share it. There are two versions, one with recesses for the screws so that they are flush and…
I have constructed a small simple clip to attach the Bowden tube to the cable conduit. Fits tightly and firmly without slipping and stabilises both hoses. To vary the clamping force, it is sufficient to scale the clips in height.…
I like to use the small gas burner lighters because the larger ones, for crème brûlée, simply take up too much space. However, the small versions have one disadvantage compared to the big ones and that is the lack of a stand. This means…
Here I have a small food bowl for rodents, for example, which can be hung in a cage. The bars should not be thicker than 3 mm. The bowl has a small bulge to stabilise it so that it does not wobble around. The bowl has approximately these…
I constructed a small, simple stand for my vape box so that it doesn't constantly tip over on my couch (or any other unstable surface) and drip all over everything. In my case, the Voopoo Drag 3 and the Aegis Legend 2 fit perfectly in the…
For the Ikea LÅNESPELARE I have designed an adapter with which it is possible to use normal sized cups in it without them tipping through the handle. There is a simple and a "stable" version available. So far I haven't had any problems…
I have constructed a simple holder for drink cans so that they do not tip over so easily on unstable surfaces. It fits normal beverage cans with a maximum diameter of 66.00 mm. So all normal 330ml or 500ml cans. Otherwise, of course, any…
Since the holding devices supplied were either cumbersome or impractical, I constructed a holder for the water bottles myself. This holder is available in different diameters from 50 mm to 70 mm and should easily fit in the most common…
These are all currently available results.
