Counting matching models…
The S2 version of the dryer goes up to 70C, so I figured this is enough to dry reusable silica gel or even annealing PLA prints. This tray goes on top of the rollers so that things don't touch the heater directly. Fits both of Sunlu's…
Flexible materials recommended. Tested in TPU95 Supports not necessary if printed in upright position. 0.4 outer wall, 0.6 inner wall for optimal result.
Print in TPU or whatever flex you have. Concentric supports in the center are not necessary to remove, but may gather dirt. May need scaling for your bath/sink.
Haven't seen replacements anywhere for sale, so here you go. Modelled after a badly beat-up original, so geometry may differ. Print Settings Printer: Flying Bear Ghost 5 Rafts: No Supports: Yes Resolution: 0.2 Infill: 25% Filament: Eryone…
Link for the T-nuts https://www.printables.com/model/228663-t-nuts-for-ikea-skadis-pegboards Holes pre-modeled at 3mm diameter (I used M3-remixed T-nuts)
WARNING: SKETCHY This simple print turns Parkside pump action drain cleaner (or similar, with a 20mm ball attachment) into a powerful and surprisingly precise single-shot nerf blaster. Print in hard TPU or similar flexible material. Mine…
These are all currently available results.
