Counting matching models…
Inspired by RJ Design's Impossible Vortex and Pyramid, but redesigned from scratch here with my own pitch, lobes and external shapes and models. ALL of these are my own design from OnShape with no measurements or copies or work taken from…
I made this to try to deal with the tendancy of the right side of prints not looking as robust as the left side when printing overhangs. Specifically, my 3DBenchy's have a tendency to warp/melt a little on the bow overhang but ONLY when…
I created this to allow mounting the Knomi V2 in my 5MPro (you must be running KlipperMOD to get actual data on Knomi…see below). It will work in normal 5M as well and a Knomi v1 and opens intake venting along the sides and places the…
I wasn't happy with the jigs that existed already (didn't fit my washers or my larger 8mm stamp tools) and the ones I saw/tried to print, seemed to stomp over the other letters. So, I just jumped in OnShape and created my own. Should…
Printable with minimal supports (only needed on bottom flange as back prints fine at 45' angle). Recommend at least 3 walls and 20% infill.
I love the idea of putting a spool in the chamber. Preheats it, dry's it (some) and seems like a good thing. But only if you can swap new spools out fast/easy. I really didn't like the idea of having to loosen a screw to remove a spool.…
Designed a corner mount bracket to fit the ¼"-20 tripod mount screw for a Logitech C920 (should fit pretty much ANY camera with a normal tripod mount screw). Has attachments for the bottom of the extrusion or the inside. Print with…
Designed this crate to hold my 65mm and 75mm whoop drone quads. I print it with text removal into the lid. Recommend ASA or ABS for strongest function, but should work with any filament. It is tight enough on clearances to ratchet on and…
Needed a bracket that I could mount one of the common rectangular digital temp / humidity sensors to my 2020 extrusion. Works for top/side or bottom mounts with blind tnuts.
Webcam block mount meant to use 2x M3x10mm screws and blind t-nuts in 2020 extrusion with Logitech C920 webcam removed from enclosure to just raw PCB. Has pocket / space for a small heatsink to be used on the back of the main processor…
Much more robust re-enforced support bracket for Siboor Trident HDMI 5" screen. Still prints great without supports and would recommend printing with strong support settings, namely 4 walls, at least 25% gyroid infill and 0.20mm layer.
Print with ABS/ASA for in chamber corner mount of webcam (34mm on center holes but 38.5mm width clearance and 45' angle down tilt. Prints without supports if printed on back.
These are all currently available results.
