P
PrintablesLeif
holder for Festo 4mm valve
Just a simple holder for the common 4 mm festo valve common in RC jets. These are marked for smoke or fuel. I porrint mine in PLA. Use Zip ties to hold the valve in place.
- Downloads
- 150
- Likes
- 7
- Rating
- 0
All models
6 models
P
PrintablesLeif
Holder for Kingtech Telemetry module
printed without supports in PETG, but PLA will probly be fine
- Downloads
- 140
- Likes
- 4
- Rating
- 0
P
PrintablesLeif
tubing holder for dual 3mm festo tube
simple clip to hold festo 3mm tubing commonly used for retracts in model aircraft. theese clips help keep the tubing runs clean inside the model. I printed them in PETG, but PLA might be better, less stringing
- Downloads
- 81
- Likes
- 2
- Rating
- 0
P
PrintablesLeif
Mercane Widewheel pro Charge port cap
I needed a replacement cap for the chargeport on my electric scooter. so I modeled in in Fusion 360 and here is the result.
- Downloads
- 31
- Likes
- 2
- Rating
- 0
P
PrintablesLeif
Mount for Robart Retract valve
I needed a new mount to hold the retract valve arm in line with the servo arm. This will give the smoothest possible action and minimal servo strain.
- Downloads
- 22
- Likes
- 1
- Rating
- 0
P
PrintablesLeif
Diatone F35 Rear antenna holder
This will fit over the rear standoffs for the Diatone F35 Quadcopter and allow mounting of a pair of ELRS linear antennas and a caddx Vista og walksnail Avatar lollipop antenna on the opposite side. I using a walksnail Avatar vtx you may…
- Downloads
- 15
- Likes
- 0
- Rating
- 0
These are all currently available results.