All models

8 models

Weekly pillbox

Weekly, 2-a-day, pillbox.

Downloads: 118
Likes: 7
Rating: 0

Twice a day, monthly pill organizer. Tried PETG and PLA, both print well however the PLA seems to print a little looser. I glued the numbers on the tops as this makes the print faster and less waste .

Downloads: 115
Likes: 15
Rating: 5

Order a print of this model

PrintablesSmity3Dprints

Home Depot bucket lid

This is a lid for the small Home Depot bucket. This is not for the 5-gallon!! I used TPU for the AMS, but any TPU would work, PLA and PETG might work, I haven't tried them yet. This is 240mm across.

Downloads: 74
Likes: 4
Rating: 0

Order a print of this model

PrintablesSmity3Dprints

Basic Pry/Scraper Tool

Make sure to reorientate it flat. Printed it in PLA with 25% infill.

Downloads: 53
Likes: 1
Rating: 0

Order a print of this model

PrintablesSmity3Dprints

Mopar Dome Light Lens

This was designed for a ‘67 Satilite, but should work on most late 60’s mopar. The one pictured is printed in PLA. I would recommend PETG for better heat resistance.

Downloads: 40
Likes: 6
Rating: 0

Order a print of this model

PrintablesSmity3Dprints

Large Spool Gear for Python with TPU Gear

This is the large spool gear for the Python AMS. I designed this to have the outer printed in TPU and the inner in PETG. If using TPU for AMS, use the plate with gear and ring on it. If you are using regular TPU, then use the separate…

Downloads: 33
Likes: 4
Rating: 0

Order a print of this model

PrintablesSmity3Dprints

Can Holder

Holds a can to the edge of the wire shelf rack.

Downloads: 6
Likes: 0
Rating: 0

Order a print of this model

PrintablesSmity3Dprints

Oven Mitt Holder

Simple holder for silicone oven mitt. Sits on top of the stove(must have a gap between stove and wall). I printed in PTEG, but PLA should work fine as well.

Downloads: 5
Likes: 0
Rating: 0

Order a print of this model

These are all currently available results.