Counting matching models…
This is a basic set of 3D printed sim racing pedals using hall sensors for accelerator and clutch, and a load cell for the brake. I use the accelerator and brake almost daily for a little over a month as of the original posting - the…
Last update: 2025-09-20 (Notes at bottom) This is a basic set of 3D printed sim racing pedals using hall sensors for accelerator and clutch, and a load cell for the brake. I've used all three pedals for ~1 month, daily, as of the original…
Updates: Sept 06, 2023 There was an error in the thumb cluster PCB where the navigation switch was lacking its common/column pin and was tied to ground - resolved on GitHub for the KiCAD and gerber files. If you have an older PCB, you can…
Bracket that clips on to the base or top or both (short sides) of a Netgear WAX206 to allow for wall mounting. I've found one bracket holding the bottom of the router to be fine, but if it's likely to be bumped or jostled printing a…
These are all currently available results.
