Counting matching models…
Humidity is a killer. On the Creality Space Pi dryer, there are holes for pfte tubes and venting moisture. I've made some plugs to fit the vents. I put them in, after drying to keep out the moisture. There are 2 kinds, a thinner top one…
PLA with defaults at 0.12mm high quality Turned on ironing on top surfaces 60mm/s, 30% 0.2mm
I printed this in PETG with: 0.16mm High Quality 50% Sparse infill 50% Infill/Wall
I have a changing station next to the fridge, needed a way to declutter the area and move the bulky over the ear headphones while they charge. Decided a magnetic holder was the way to go. There is also a thin tpu pad to keep from…
Bambulabs P1S, generic pla, set up as bambulab pla basic. 0.08mm Extra Fine 25% infill / Cubic Ironing on 55mm/s 33% 0.2mm 0mm Ironing Inset
I had been trying to organize my power tools and am using a board under a shelf to mount different printed items (power tool holders, battery mounts, etc) but to get the board in, I had to trim it down, which led to problems when trying…
These are all currently available results.
