Counting matching models…
After the original feet that came with the toilet seat fell out, often disappearing down the toilet itself, I made replacements to fit where the originals had been. Printed in coloured PLA to match the decor of the bathroom, 80% infill to…
The door to my greenhouse did not come with any type of handle so I created this one to make it easier to open the door from both inside and out.
This design was created for the AOSOM greenhouse that is in my garden, it comes with built in gutters but no downpipes. The connector attaches to the hole for the downpipe and fits to a hose that can then be fed into a suitable water…
After the old feet on our clothes airer wore through and it started scratching the floor and leaving rust stains, I designed new feet that are correctly angled to sit flat on the floor.
My daughter has been using small, 10cm square canvases to paint pictures onto and wanted a simple stand to display her work. These stands are small and light, take only 7 minutes to print and hold the canvases without covering much of the…
My dad asked me to make a cover to stop him turning off his bedroom light switch as he has a remote control fan and light fitted. Made in Tinkercad, this model covers a single switch with a slot on it to be able to turn the switch on/off…
These are all currently available results.
