Counting matching models…
This is a schwimming pool chlorine floater/dispenser for those big 200g pills. The print has two parts. No support needed. I used ABS and PETG, but Josef Prusa recommends ASA (better UV & chlorine resistance). 20230525: Uploaded V3 -…
A simple adapter for 4mm Bits to 1/4inch hex. Print instructions Unassociated tags: 1/2inch Category: DIY Summary A simple adapter for 4mm Bits to 1/4inch hex.
No need for soldering anymore - just put the pin headers on the Wemos D1 mini and place the Mini Breadboard on top. Use some pressure to sandwitch everything together. Print the Mini Breadboard upside down and you do not need any support.…
Use your Bosch 18V Power4All batter pack as USB power bank adapter for charging up to three devices on the go. IMPORTANT NODES: The 18V lipo battery packs are usually unprotected (with no charging or discharging circuit on board). Take…
If you are into smd soldering than this thing will make your live much easier. The smd turntable consists of a base and a "donut" with compartments for your project-specific smd components. Each compartment can have it's own label (for…
A simple holder for your probes (multimeter or oscilloscope). Fits to your wall (with a single screw) or you use adhesive tape and place it directly on your workbench. Have fun! @tstoegi Print instructions Category: Electronics Summary A…
I used a semi-transparent PLA to see what kind of attachment is inside. Brim is recommended. No support needed.
My screwdriver came with 8 hex bits in total, so I printed 2 holder. There is space for a maximum of 8 hex bits (2 holders) inside. Brim is recommended. No support needed. 0.2mm layer - PLA. Don't worry about the difference between the…
This is a replacement part for a broken Ideal Standard shower knob.
These are all currently available results.
