Counting matching models…
The PTFE tube on the KLP1 is not held in place and is not fun to load or unload filament. This mod takes 2 2.5mm zip ties to hold the output of the FRS and a 22mm PTFE tube on the load side of the FRS. The PTFE lines up with the in/out of…
Print using PETG, ABS, Carbon Fiber, or ASA. I used ColorFabb XT-CF20 - .2mm at 50% infill. I have had this in my car for over a year and no issues with warping. Use supports for the Phone cap and the MINI Cap. The phone mount was made…
I used .2mm layer height, .4mm nozzle, and 20% infill. No glue was needed for the male connectors but could use a little hot glue or gorilla glue on the female connectors. Tested on MK2.5S and Ender3 Pro.
This original works great for BL Touch but did not fit CR Touch. I had to use an extension plate on my Ender 3 Pro.
I made this for a senior center in Vermont and unbranded it for the this site. Easy to add text. I printed this on an Ender 3 a few years ago, but you could fit the entire tree on a large printer or scale it down. Included is a the entire…
.2mm height - printed on MK2.5S and Ender 3Pro. No supports needed. This is also keyed so you cannot mess up polarity. I used a little bit of gorilla glue to hold it in place, but it is tight enough on its own the way it is.
Moved the filament runout sensor to the left side for easier loading and unloading. I have a filament dryer that connects directly to the sensor. You will need to extend the wire. I used a male and female 3-pin XH-3Y and XH-3A to extend…
These are all currently available results.
