Counting matching models…
I designed it so 2 sets could fit on a Mini. I designed it with a .8mm nozzle in mind but it prints fine with a .4mm nozzle. It fits ½" electrical conduit and they should be plenty strong on a 16" stud spacing, all mine are just into the…
The Musclerack I bought from walmart does not use post connectors to attach the top and bottom posts together but instead uses the shelving beams to connect them. Thats fine and all unless you dont want a shelf there which was my case.…
Tired of waiting for my dishy to come so I made my own.
I extended the duct 9mm for my mk3 after I purchased a meltzone extender off of Aliexpress.
Its hard enough working with all those small pieces trying to mount them, hopefully this will make it a little easier.
This is a mold for a sock if you are using a meltzone extender. It fits V6 blocks and similar ones like the dragon. I use the female portion of the mold as my mix pot. I load in 7 grams of part A and then mix in the appropriate amount of…
The first problem with the stock solution is its 3 separate tubes. I run my Minis hard and replace the Ptfe every 2-3 months so I want to use Quick disconnect fittings, I Found some 8mm thread/4mm bore fittings but they didn't allow you…
These are all currently available results.
