Counting matching models…
The Ryobi plunge router came with a clear dust collector piece that attaches a vacuum hose vertically to it. It is prone to cracking and I didn't like the angle of the vacuum hose coming out. It also wouldn't work with my new camlock…
I wanted a holder for my die set. It covers the Kincrome dies from M4 to M12 plus some added extra dies I had lying in my drawers. Its based around a 25.4mm or 1 inch die. The other die holders i found too up too much space. This print is…
This model adapts a 75mm standard VESA mount to a 50mm collar to suit the common digital microscopes you see on aliexpress and the like. The aluminum collar is 50mm in diameter and the recess for the mount is slightly larger to allow for…
Stores your oil in a gridfinity holder. Does not have magnets cut in the bottom.
I wanted a holder for my tap set. It covers the Kincrome taps from M5 to M12 plus some added extra taps I had lying in my drawers. The other Tap holders i found too up too much space. This print is a small 3x1 Holder and under 100mm so it…
Useful for mounting your icharge unit under a shelf for easy access and holds in place while plugging in and out. Recommend to use a bit of double sided tape to aid in holding the charger in place. Needs 4x 7 gauge bugle head screws to go…
Useful for mounting your HR1520 Short Killer Power supply unit under a shelf for easy access and holds in place while plugging in and out. Recommend to use a bit of double sided tape to aid in holding the supply in place. Needs 4x 7 gauge…
I installed a new tap spigot in the garden and then wanted to mount a retractable hose to the post. Without drilling it, there were not that many good options. I have used square u brackets in the past but they look ugly. A simple and…
I wanted a bracket to install my 21700 test jig on my wall. You can wire up to the terminals on the outside of the 8 channel tester. You can only test either 18650 or 21700 per slot not both at the same time. I feel it is a neater and…
This holder is designed to display and hold 32 Wera Kraftform Kompakt bits. The set is 33 piece which includes the driver handle. There is 32 slots in this holder. Each holder has a spot for a 6mm x3 push fit magnet so there is a…
I wanted a quick and dirty way to mount my A-Torch tester on the wall. I had already printed a great case for it. Firstly tried double sided tape but the heat of the unit softened the double sided tape and made it fall off. I used 6G…
The bearing retainer on my customers lawn mower broke so I created a replacement. I personally printed it in Nylon PA-12 CF for maximum strength. If you dont have that filament and want the strongest possible replacement I sell them on my…
The legs on these cheap clothes airers from bunnings are prone to breaking. I designed this not to save money but to save waste really. This fits on the leg as shown. It may fit the diagonally opposite side, but I havent tested it. You…
Replaces the missing brace piece from the practa clothes airer clothesline
These are all currently available results.
