Counting matching models…
Wall mount for wired Xbox 360 Controller, with cable hook. Test print of v1 would work well for a wireless controller, however on the wired version, the cable is too close to the wall and doesn't sit well. also the hook was too small to…
1911 magazine holder, up to 6 single stack magazines. Works with .22 caliber magazines as well.
Basic model of the small dungeon key from Ocarina of Time. Will update once I get a chance to run it through my printer Added a second model which is smaller and added a keyring. Category: Video Games
Charm version of Ela's operator icon from Rainbow Six Siege. Needed a lower resolution model to print at smaller sizes on my MPSM v2. v3 - test printed decent (see photo), though I'm not super confident in the keyring (rounded) v4 -…
Dual pmag holder that works with the open armory louvered wall system.
Use wallmounts from Open Armory: https://www.printables.com/model/413796-open-armory with MDF slatwall/slotwall panels. Access to the edge of the panel is necessary, these are slid in from the end. Two widths provided, full and half…
Wall mount for beretta magazines. Holds 6. Adapted for use with slotwall / slatwall and my adapters.
First iteration of a 3D printable whetstone bridge, for manual knife sharpening over the sink. There are similar designs, where this one differs most is the use of metal channel rather than threaded or linear rods. I went with aluminum…
These are all currently available results.
