Counting matching models…
See pdf for instructions. Just added a hole sleeve bushing .stp file to prevent chafing of the wood shelf holes instead of oversized T-nuts. If I do again: Heated threaded brass inserts in lieu of threaded “cold” inserts (what the…
3 part housing for the Noyito 4 channel USB relay board to control power to 12VDC astronomical support devices using an ASCOM driver. See original model post for the link to the ASCOM driver needed. Used Prusament galaxy silver, .8mm…
A removable bracket or the Pegasus Pocket Powerbox (PPB) Micro that clips onto a 1.75 tripod tube The tube clip is just pushed onto the tube and also has a bolt and heated insert to secure further. The PPB is attached to a bracket via two…
A shelf for the Mele Quieter 4C mini PC that fits on the iOptron 360 tri pier. It uses the pre-existing 3/8" threaded holes on the top plate to mount the shelf. Since the fanless Meles run hot, I designed a bracket to mount the Mele . The…
I am of the “keep everything off the OTA” camp vs. “put everything on the OTA but the kitchen sink” camp. With that in mind I designed and printed the models you see on this page. I share the mele with a “permanent” iOptron 360 tri-pier…
Printed with .8mm nozzle and Yellow PETG at 240/90 degrees. Prusa MK3+ 3mm brass heated inserts for all screws. Be sure to print the loom part so the loom is horizontal and flate on the plate. Printing the loom part in the vertical…
3 part housing for the KMTronics 4 channel USB relay board to control power to 12VDC astronomical support devices using an ASCOM driver found here: https://www.digitalastrophotography.co.uk/observatory-project.html Board source:…
A friend of mine asked me to print a solution to guide/route his cables on a large Takahashi refractor. He has a motorized flat panel on the front, power box in the middle, and imaging equipment in the rear, some of which are relatively…
Printed with PETG. I designed this over my frustration with the commercial product I own. This brand's parts are glued together and tended to break apart if dropped. Designed to avoid support material. Parts list 4 - M6 x 18 socket head…
This bracket holds the Hubble Optics artificial star and mounts it to a standard 1/4"-20 tripod screw mount. The laser uses a vixen dovetail bracket that mounts to the bottom vixen rail of an SCT. The laser is used solely to point the OTA…
This bracket holds a small laser and mounts it to a vixen rail. The laser is used solely to point the OTA at the artificial star and turned off once accomplished. See part one for the Hubble Optics Artificial Star bracket. PETG, .8mm…
These are all currently available results.
