Counting matching models…
Designed this to be simple and easy to print. The one in the photo is printed in TPU, as I figured it would withstand crashes a bit better. However, at this thickness it is a bit floppy.
Default skids with added bumpers to protect the carbon somewhat. Remixed to make a couple of the screw holes larger so the button head goes all the way to the carbon, to better secure the motor. Note you will need shorter screws Print…
Obra Dinn pocketwatch. Print Settings Rafts: No Supports: No Resolution: 200 Infill: 20 Filament: PolyMaker PLA Category: Props
A slip on cover for the HD-3000 webcam
Modified the official SMA mount to hold the DJI MMCX antenna. Other designs were a bit tight with the cable fit so these tubes are a bit longer. Also the bottom antenna on other designs dipped below the bottom plate causing the quad to…
A drip stand for a V60. Designed to fit mugs between a diameter of 82mm and 99mm Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 0.2 Infill: 20 Filament: Any PLA Category: Kitchen & Dining
Snakeboard logo. Designed to be printed with multiple colours
Designed with WSA measurements, these trucks will allow you to practice your streetboarding grabs, spins and flips on a trampoline, without worrying about damaging anything. The test pair I've printed so far have been in PLA (20% infill).…
Remixed the shell to be slightly larger, so the gopro slips in and out a bit easier (still a bit tight). Includes 20 and 30 degree versions Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: Yes Resolution: 100…
Based on the official design that comes with the TransTEC Freedom HD Frame ( https://www.thingiverse.com/thing:3917318 ). However, I found that the original is too short, making the wires/connectors hard to install. With the longer mount,…
Riser pads that match the contour of the ViaLow trucks. 5mm thick
These guides are meant to aid the rigidity of the bindings, to quickly and easily place you foot in without the bindings getting in the way. Without them, the bindings tend to flop down, requiring a hand or two to move them out the way…
Needed something to mount my board flush on the back of the door. Complete with the Dragan Boards logo
Spare washer for the Dragan Streetboards bindings. With or without logo
Extended the protection around the camera Print Settings Rafts: No Supports: Yes Resolution: 200 Infill: 20 Filament: PolyMaker TPU Category: R/C Vehicles
These are all currently available results.
