Counting matching models…
I recently ordered one of these: https://www.amazon.com/dp/B0017ASRTI And it did not come with nearly enough dividers, so I decided to make this thing so I have extras. This is designed so you can resize it in your slicer to fit your needs.
Stand for toothpaste that attaches to the shower wall with double sticky foam tape.
UPDATED: 10-04-2024 @falo advised there is a gap between the top and the cylinder. I uploaded fixed files to eliminate this gap. Just a heads up if you need larger or smaller sizes you can resize this in your slicer software of choice.…
R18 10x15mm drag chain mount for wire routing Edited to add photos of linear rail mounting option.
I made this to go along with the 100 Hex Project: https://tecnoloxia.org/100hex/ https://www.thingiverse.com/thing:2477471
This is the first 3D Model I created and printed! It's basic, but does it's job well. I like to grind up my bud and keep it in pre-roll joint containers to dump a little into a bowl at a time. I like to have a variety of different…
I use a spool holder similar to this, so I wanted to reinforce the center holes a little: https://www.thingiverse.com/thing:4208201 Outer Diameter on inside circle is 55mm.
This is a fixed remix of the Spiral_28 design by: https://www.thingiverse.com/pelandintecno/designs https://www.thingiverse.com/thing:4524116 100 Hex: https://tecnoloxia.org/100hex/ https://www.thingiverse.com/thing:2477471 When…
Remix of AnthonyB's NEMA23 Dragchain mount: https://www.thingiverse.com/thing:459285 This will slip on the Micro Swiss NG's Extruder stepper and has 2 screw/nut holes
I loved the frame designs for this project. Unfortunately there wasn't a case to install the electronics into. I imported the frame and cover into Tinkercad and made my own modifications. I blanked out the back, and added mounting pegs to…
This is a stand for the Nevermore Micro v5 Duo filter for the RatRig V-Core 3 enclosure. It is a remix of the Electronics Wire Guide Rear from the original official repository. The 2nd photo is of the original part I used for the remix.
These are all currently available results.
