Counting matching models…
A set of spacers designed to advance a single piston or two pistons on the same side of the caliper. There is a left and a right side spacer that advance a single piston in the case of a sticky piston or to clean each piston. There are 4…
Printable UDH hanger. Not sure that I would trust a printed hanger long term but if you need it for a ride and can't get to a bike shop it could be the ticket. I should clarify that this is not a truly universal hanger. Universal…
Designed for the Zeb but should work on other 38mm forks. Confirmed for Fox. Works as good as any commercial tool. Prints without supports. Use high infill. UPDATE 9/2023 - By request, I thickened the tool's outer flange by 1mm. This is…
Has marks for adjusting B tension on 30t and 34t cassette cogs. The top of the gauge is for 28t cassettes. Replaces the paper gauge that comes with the derailleurs (Shimano “GG Adjustment Gauge” Y3GK89600) and I have added a lip to make…
Mercedes Sprinter van model shell. Hollowed out remix with extra reinforcements for the side view mirrors. Built around a 133.5mm crawler chassis. Printed upright with internal supports but could save a lot of print time and material by…
Slides into the original EDC V1 steer tube system. Swap the o-rings from the original tool carrier and slot the multi-tool into the recess. There is a backstop on one side to rest against the tool and keep it snug. I hated the tire lever…
Lower slider attachment for MRP SXg chainguides. MRP calls this part the Whippersnapper, it has the bashguard and chain guide in one unit.
The fan blades all broke on my electric lawnmower so designed a version with wider, supported blades. In order to print the fan with no supports I redesigned the blade insulator to work with this specific fan. The printed fan must be used…
Easily snaps into dish rack to support bottles upright while drying. Works on racks with 6mm bars.
Sits in an EDC V1 steer tube with a OneUp top cap. Has a recess for an o-ring. Prints upside down with no supports.
Small clip to prevent the handheld showerhead from rotating while in its cradle. The clip-equipped showerhead slides as smoothly into the cradle as it does without the clip. This is modeled around a Moen Eos showerhead. Prints quickly and…
Zip ties on to the clamp carriage of an EZ lift stand and holds your 3-in-1 inflator securely.
These are all currently available results.
