Counting matching models…
Chased the right height around for a while for the Mercury ZeroG Plus version, then just said the heck with it and made it adjustable. See original model for the bucket and information about the wiper macro. Print Wiper_Body on its…
My v0.1 with a custom toolhead couldn't pick up the zeroclick probe because it didn't have enough Y travel. I needed to move it 2.6mm toward the print bed. This was the result.
I added an O-ring to the stock BCAR (Ok, “SCAR”) in the groove at the front. I think that's what it's there for. The cover then friction-fits over the stock BCAR. This is longer than the stock BCAR and will fit over and integrate well…
If you use a sealant or glue on the cover side of your valve cover gasket, this helps keep even pressure on the gasket all the way around the edge until it has cured. It's a tight fit in the cover - mine works perfect, but I can imagine…
I designed a case for the Sapphire infusion pump for our helicopter EMS company. It is a standalone accessory, and doesn't have a provision for mounting to an IV pole. <Note: I have a couple of changes to make before I'm happy publishing…
These are all currently available results.
