Counting matching models…
This bracket screws to the factory locations on the front risers to hold an RGBW led strip. I installed a 12v RGBW strip and it is plenty bright enough to illuminate the entire chamber. Powered by a LM2596 and controlled with an ESPCAM…
A mount that holds an espcam board where the stock FlashForge camera goes. I got a 5-pin JST connector and powered it from the stock port on the back of the LCD. With some know-how, connect the camera to Home Assistant or other smart-home…
I didn't like the drawer you can place under your Bartesian drink maker, and I already had cabinets and drawers. I still wanted a way to show off my addiction so I designed these holders that prop the pods up in a way that the name of the…
I built this model to hold a non-epoxied 10mm LED strip. It is designed specifically for a under-cabinet lighting situation that holds the LED strip at a 45 degree angle. I like the 45 degree angle because it then I can't see the LEDs…
I had some closet doors that weren't staying shut. I tried bending the hinges to angle the door up, but they kept sagging back down and again wouldn't catch. So instead a sketched up a shim that fits between the strike plate and the door…
My 1978 FORD Gen2 Bronco restoration project was missing a plastic seat lever on the passenger side. My modeling isn't the highest quality, and some measurements may be slightly off. But you can't purchase these even from LMC, and for…
I needed a bracket that would hold an ESP32 to my gas meter so I designed this. I made it snap on without any kind of permeant adhesion to the gas meter, since in the United States we don't typically own our gas meters. Seems to hold it…
These are all currently available results.
